IMPORTANT! Please follow instructions carefully.
GENERAL HINTS: Proper fit and function of this Molded Roof Rail Seal depends upon correct adjustment of the top frame relative to the side windows. Do not expect this weatherseal to automatically fit every car without some adjustments. Consult the factory service manual for top adjustment details. Our Convertible Top Roof Rail Seals are crafted with quality for a beautiful replacement. Enjoy!
A. PREPARATION: Remove all old pieces from roof rails and header. Scrape out and clean all foreign material from roof rail frame.
B. ADJUSTMENTS: Adjust door and side windows so that there is an even gap of about 1/2” along top edge of glass to back roof rail.
C. ROOF RAIL SEAL INSTALLATION: Install the driver side and passenger side long straight pieces, plus corner pieces, to header.
D. HEADER SEAL INSTALLATION: Cut sponge rubber header seal to proper length (if molded ends are connected to side rails). Use 3M “Super Weatherstrip Adhesive” to bond to header. Trim ends neatly to fit flush with corner pieces.
E. ADJUSTMENTS: Note that molded holes in side rail pieces are somewhat oversized. Position front side rail pieces laterally so door glass top edge enters groove in weatherstrip. (Note: Angle of aim on all side glass may be adjusted by inside-the-body adjustments. Please consult factory shop manual for details if needed.)
F. RECOMMENDATION: It is recommended that silicone spray lubricant or Armorall (available at any hardware or auto supply store) be used on all rubber pieces where glass meets rubber to prevent excess friction.
G. TO FINISH: Position remaining side rail pieces as per Steps E and F.